Klein Tools 32327 Precision Screwdriver Set, 27-in-1 Multi-Bit Screwdriver, Onboard Storage, Rare-Earth Magnet, Ideal for Terminal Blocks

This is easily become one of my favorite tools to keep in my tool bag. It's precise, easy to use, and I haven't had a problem with any of the bits slipping.

This is a must-have tool if you're working on laptops. Has a complete selection of bits stored under the rotating end cap. Bit storage pulls out easily and each bit is securely snapped in the holder. Rotating cap does not unscrew but rotates freely. Bits are well made and fit snugly into the magnetic shaft.Good value. Add it to your tool kit.

Good screw driver with lots of function.A little heavy (80 g with all the bits inside)3.5mm driver and bits3.25 inch shaft reach with the bitToo long to fit in shirt pocketI was looking for a precision bit screw drive that was easier to cary than a case with lots of bits (I have the ifixit kit mako driver kit) this fit the bill nicely.The screwdrive stores the bits in a friction fit, pull out compartment that is in the tail end of the handle. The handle is covered in rubber like most Klein screw drivers. The bits are double ended 3.5mm. The bits are not magnetic but the driver shaft is. It will not have any issue holding onto small screws.The bits included are:Flat 1.0 mm / Flat 3.0 mmFlat 2.0 mm / Flat 3.5 mmPhillips #000 / Flat 2.5Phillips #00 / Phillips #1Phillips #0 / Phillips #2Hex 0.9 mm / Hex Security 2.5 mmHex 1.3 mm / Hex Security 3.5 mmHex 1.5 mm / Hex Security 3.0 mmHex Security 2.0 mm / Torx 3Torx 4 / Torx Security 9Torx Security 5 / Torx Security 8Torx Security 6 / Torx Security 15Torx Security 7 / Torx Security 10

Great Klein tool. The bits are very small. So keep that in mind. All Klein products are good quality. Highly recommend.

This tool is great and saves room in your tool bag.

Great little screwdriver, but from the pictures I thought this would be something I could carry in my pocket. It is not. Much bigger than I assumed. Doesn't fit in my pocket protector. Even if it did the bits are too short/thick to fit in most screw terminal holes anyway. Still not sorry I bought it, I just don't use it much.

Great tool for smaller bits. All in one. Stars. Allens. Phillips. Flatheads. Great for electronics, firearms, glasses..etc.

Great for using on terminals blocks. Handy and has different tips .